OUO 101011 Long Gusset Adaptable Traction Bar Kit
One Up Offroad Long Gusset Traction Bars are part of our Rear Traction Kit and sport a larger gusset for a beefier look that complements larger trucks and higher lifts perfectly but look great at any height.
OUO 101029 Traction Bar Hardware Kit - Dodge No-Drill Mounts
Frame Mount Option for Traction Bar Systems. These Frame Mounts install easily bolting around the frame and provide a pivot point and mount Beside the truck frame for OUO Traction Bars. Includes Mounts and necessary installation hardware. Traction Bars and Traction Blocks or Axle Mounts and Lift Blocks Sold Seperately for easy customization.
OUO Traction Bar Hardware Kit - Beside Frame Pivot Mounts With 601028 Blind Bolt Kit Included
This mount is beside the outside of the frame it is also centered on the bottom flange so it has the highest ground clearance on the market. If you're leaf springs are on the outside of the frame this is most likely the bracket you're going to use. If you have a Dodge Gen4 truck with amp steps you should run the 101022 so that the amp steps clear the frame mount. If you have an F150, Toyota or other vehicle where the leaf springs are underneath the frame you want to run the part number 101022 under frame mount.
OUO Under Axle Bar Mount, 4 1/2" Axle, U-Bolts Down
This axle bar mount is used with the U-Bolts pointing down in the truck.
U-Bolts pointing down configuration have the U-Bolt nuts on the bottom, under the axle.
The axle tube diameter must be 4 1/2 inch to use this bracket. We have other axle diameter brackets available, so if your truck does not have a 4 1/2 inch axle we do have a bracket for your truck.
Many trucks come from the factory with U-Bolts pointing down, like most GMC’s, Chevrolet’s, second generation Dodge's as well as 2011 and newer Ford Super-duty’s.
On many trucks, if the U-Bolts are still in good shape they can be reused when installing this mount.
This axle bar mount works on most trucks with 3 inch wide leaf springs.
This very high quality axle bar mount is cast alloy steel and comes beautifully powder coated satin black.
The powder coating is done in one of the best shops in the northwest. Each part gets sand blasted and dipped in phosphate on a production automated coating system to be sure it is the best coating we can possibly produce.
Every part is hand inspected before and after powder coating to be sure the part meets out high quality standards.
OUO 101020 Traction Bar Hardware Kit - Beside Frame Mounts
This mount is beside the outside of the frame it is also centered on the bottom flange so it has the highest ground clearance on the market.
If you're leaf springs are on the outside of the frame this is most likely the bracket you're going to use
OUO 101030 Axle Bar Mounts - Weld On, Max HP
Made for U-Bolts Up suspension configurations, these weld-on mounts provide a simple, quick and easy installation for traction bars to the axle and are designed to not warp the axle tube during welding.