Home > Ford > Ford Powerstroke 1999-2003 7.3L > Intercoolers
Sort By:
Page of 1
DIESELSITE 1999-2003 7.3L INTERCOOLER BOOT KIT DIESELSITE 2003-2007 6.0L INTERCOOLER BOOT KIT (WITH STEEL TUBING ONLY) ALSO USED ON 99-03 7.3 TO SWAP 6.0 INTERCOOLER DIESELSITE 1999.5-2003 7.3L ENGINE BOOT KIT (AFTER 12/1/98)
The kit includes the two boots that connect the intercooler piping to the intercooler on both sides of the radiator. It includes four T-bolt spring clamps. The spring bolt clamps are 300 series stainless steel with zinc coated bolts with a 300lb clamping strength. Recommended torque is 60 in/lbs. The kit includes the two boots that connect the inter-cooler pipes to the inter-cooler. It includes four T-bolt spring clamps. The spring bolt clamps are 300 series stainless steel with zinc coated bolts with a 300lb clamping strength. Recommended torque is 60 in/lbs. The kit includes the two boots that connect the intercooler pipes to the intake manifold, and the two boots that seal the intake manifold to the heads. It includes four T-bolt spring clamps for the upper boots and four heavy duty stainless steel clamps for the lower boots.
DIESELSITE REPLACEMENT BOOTS FOR VARIOUS APPLICATIONS: 3" ID X 4.25" DIESELSITE REPLACEMENT ENGINE VALLEY BOOTS FOR EARLY 1999 SUPERDUTY DIESELSITE 1999.5-2003 7.3L INTAKE PLENUM BOOTS
The kit includes the two boots that connect the intercooler pipes to the intercooler if you have a 7.3L Banks IC or 7.3L Hypermax Tapercore. It also replaces the two upper hoses that connect the intercooler tubes to the intake manifold on the 99-03 7.3L trucks. The kit includes the two boots that connect the intake manifold to the cylinder heads on the Early 1999 Powerstroke. It includes four worm drive clamps for the boots. The spring bolt clamps are not to be used in this application as they will damage the intakes. This kit includes the two boots that connect the intake manifold piping ("Spider") to the intake plenums on 1999.5-2003 7.3L PSD trucks. Also included are four worm gear drive clamps.