Home > Ford > Ford Powerstroke 2008-2010 6.4L > EGR Upgrades >

SDP 2008-2010 Ford 6.4 EGR Block off plate set


SDP 2008-2010 Ford 6.4 EGR Block off plate set


 
Our Price: $69.99

Quantity in Stock:(Out of Stock)

Product Code: 6.4EGRBLOCKOFFPLATESET
Qty:

Description
 

Ford 6.4 EGR Lower/Bottom plate installation:

The lower plate is installed just prior to the first/horizontal EGR the runs along the left side of the engine back to front. This plate will allow exhaust flow and pressure to still reach the Exhaust Back Pressure sensor located in the EGR cooler feed pipe that runs from the back of the turbo's down to the left side of the engine. The block off plate with be installed by loosening (but you don't have to remove the bolts) enough to spread the pipes apart and slide the block off plate in front of the gasket. The plate is made with cut out bolt holes to allow this to be installed without disconnecting the EGR cooler feed pipe and the horizontal first EGR cooler (located along the left side/driver side of the engine). If you are working alone it is best to remove the left inner fender well for this install. It can be done from the bottom of the truck with a helper from the top or side to spread the two pipes apart. You must run the proper EGR delete programming to prevent a CEL.
Upper plate installation:

The up plate installs between the vertical OEM EGR cooler and the throttle valve assemble on the top front of the engine. Again loosen the two bolts to allow enough clearance to install the slip-in block off plate. Retighten bolts to factory spec.


Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

Ford > Ford Powerstroke 2008-2010 6.4L > EGR Upgrades